⚙️ Iveco Daily Gas Pressure Sensor – FAP Monitoring and Euro 6 Emission Compliance
🔧 What is this part for?
The exhaust gas pressure sensor is a differential pressure sensor integrated into the exhaust line, upstream and downstream of the particulate filter (FAP). It continuously measures the pressure difference between the inlet and outlet of the FAP to assess its clogging level. This data is transmitted in real time to the engine control unit, which triggers FAP regeneration cycles at the appropriate time. Without this sensor, the control unit can no longer manage regeneration, leading to progressive filter clogging and engine performance degradation.
This piezoresistive sensor is powered at 5V by the control unit and converts pressure variation into a precise electrical signal. It is supplied in new condition and replaces the original sensor identically on Iveco Daily MY2016, MY2019, MY2022 and MY2024 models, with no wiring or mounting bracket modifications required.
✅ Technical Specifications
Compatibility: Iveco Daily MY2016, MY2019, MY2022, MY2024
Type: FAP differential pressure sensor (piezoresistive)
Number of poles: 3
Measurement range: up to 90 kPa
Power supply / output voltage: 5V
Position: Exhaust line, before and after particulate filter
Condition: New
OEM Reference: 5801600484
Cross-reference: 5801356473
✅ Why replace this part?
✅ A faulty sensor prevents the control unit from triggering FAP regeneration, causing rapid filter clogging, noticeable power loss and increased fuel consumption.
✅ Incorrect pressure data cause the engine warning light to illuminate, FAP fault codes and may result in limp mode limiting vehicle performance.
✅ Replacement with a new sensor restores original emission control management, ensures compliance with Euro 6 standards and eliminates fault codes related to FAP monitoring.
✅ Symptoms of wear / failure / replacement
Signs of a faulty gas pressure sensor on Iveco Daily include illumination of the FAP warning light or engine warning light on the dashboard, accompanied by fault codes specific to the particulate filter differential pressure. You will also observe FAP regeneration that no longer triggers or does not complete properly, progressive power loss related to filter clogging, and increased fuel consumption. An OBD diagnostic test can confirm sensor failure before any intervention. Also check the condition of the pressure lines connecting the sensor to the FAP, which may be clogged or damaged.
✅ Installation Tips
Before installation, carefully clean the connection fittings of the pressure lines to remove any soot deposits that could distort the measurement of the new sensor. Check the condition of the 3-pole electrical connector and wiring, as well as the seal of the pressure lines between the sensor and the FAP. After installation, clear fault codes using a diagnostic tool and verify that the differential pressure values displayed are consistent with the actual condition of the FAP. Installation by a qualified technician familiar with diesel emission control systems is recommended.
✅ RAXOR Parts Technical Advice
When replacing the gas pressure sensor, systematically inspect the Iveco Daily vacuum hoses that connect the sensor to the particulate filter: a cracked hose, clogged with soot or poorly connected is enough to cause incorrect measurements and trigger persistent fault codes, even after sensor replacement. On Iveco Daily MY2016 to MY2024, this sensor works directly with the SCR and AdBlue emission control system components. Also find the full range of Iveco Daily AdBlue system parts available on RAXOR Parts to maintain complete emission control compliance of your vehicle.
✅ Why choose RAXOR Parts?
✅ New sensor OEM reference 5801600484, compatible with Iveco Daily MY2016, MY2019, MY2022 and MY2024, direct replacement with no adaptation or wiring modification required.
✅ Complementary parts available (vacuum hoses, NOx sensors, AdBlue components) for complete emission control system compliance in a single order.
✅ Stock available and fast shipping to minimize downtime for your working vehicle.
Contact
📧 Contact us by email for any compatibility questions.
💬 Use the online chat for a quick response.
🚚 Order your Iveco Daily gas pressure sensor now
Place your order today on RAXOR Parts and receive your new sensor quickly, ready to install on your Iveco Daily.